The blog of a gypsy engineer

Software security, electronics, DIY and traveling.

How to make breadboard power supply 5V/3.3V

Here is a very simple breadboard power supply that outputs a selectable 5V or 3.3V regulated voltage.

 

Breadboard power supply 5V/3.3V

It is similar to something like this

Breadboard power supply 5V/3.3V

To be honest, it’s cheaper to buy it on Amazon or AliExpress. But it’s always more fun if you make it by yourself.

Here is a list of components:
  • LM1117T voltage regulator (3.3V)
  • L7805CV voltage regulator (5V)
  • 2 x 10uF capacitor
  • 0.33uF capacitor
  • 0.1uF capacitor
  • 330 resistor
  • 680 resistor
  • 2.2K resistor
  • 3 x LED
  • 3 x Push button switch (or other switches)
  • 10 x Header pin
  • Prototype PCB board
Datasheets for LM1117T and L7805CV give up pin configurations and application circuits. There are an input and output capacitors in the circuits. The datasheets kindly provide values of these capacitors. The datasheet for LM1117 mentions a tantalum capacitor, but I used electrolytic ones, and they seem to work fine. For L7805CV I used ceramic capacitors, and they seem to work fine as well.
Here is a circuit and a calculation of current limiting resistors for LEDs. Nothing surprising, just Ohm’s law (I wrote a separate post about it). The current for LEDs is 5mA because I just needed an indication, not an illumination.

Breadboard power supply 5V/3.3V

The easiest way is to assemble it on a prototype board. Make sure that you install header pins in right place, so that you can connect your power supply to a breadboard.
Breadboard power supply 5V/3.3V Breadboard power supply 5V/3.3V Breadboard power supply 5V/3.3V

If you have found a spelling error, please, notify us by selecting that text and pressing Ctrl+Enter.

Leave a Reply

Your email address will not be published. Required fields are marked *

Spelling error report

The following text will be sent to our editors: